CyberData 011146 Operation Manual page 89

6. Select the firmware file. This reveals the Upload button
Upload button Status Messages
7. Click on the Upload button. After selecting the Upload button, you will see the progress of the
8. When the upload is complete, you will see the words Upload finished under Status Messages.
9. At this point, you will see the progress of the upload's post processing in the Upload Post
Note
10. When the process is complete, you will see the words SWUPDATE Successful under Status
11. The device will reboot automatically.
12. The Home page will display the version number of the firmware and indicate which boot
CyberData Corporation
Figure 2-38. Upload Button
CyberData Paging Server
Upload Post Processing bar
upload in the Upload Progress bar.
Processing bar.
Do not reboot the device before the upgrading process is complete.
Messages.
partition is active.
931803A
Setting Up the SIP Paging Server
Configure the Autoprovisioning Parameters
(Figure 2-38).
Upload Progress bar
Operations Guide
81