Maintenance; Safety; Preparation; Restarting - Optimum Optimill BF 30V Operating Manual

5

Maintenance

In this chapter you will find important information about

Inspection

Maintenance

Repair
of the drilling-milling machine.
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for

operational safety,

failure-free operation,

long service life of the drilling-milling machine and

the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
5.1

Safety

WARNING!
The consequences of incorrect maintenance and repair work may include:

very serious injury to personnel working on the drilling-milling machine,

damage to the drilling-milling machine.
Only qualified staff should carry out maintenance and repair work on the drilling-milling
machine.

5.1.1 Preparation

WARNING!
Only carry out work on the drilling-milling machine if it has been disconnected from the
mains power supply.

"Switching-off and securing the drilling-milling machine" on page 16
Attach a warning sign.

5.1.2 Restarting

Before restarting run a safety check.

"Safety check" on page 14
WARNING!
Before starting the drilling-milling machine, you must check that there is no danger for
persons and that the drilling-milling machine is not damaged.
Maintenance
Version 1.1.5 dated 2015-08-31 Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
BF30Vario GB
Page 37