A - Drive grounding terminal (FE)
B - Ground screw
5.
Install the option (A) into the CN5 connector (C) on the drive and use one of the
included screws (B) to put it in place.
Tighten the screw to a correct tightening torque:
• 0.5 N∙m to 0.6 N∙m (4.4 in∙lb to 5.3 in∙lb)
Note:
Only two screws are necessary to install the option on an HV600 drive.
YASKAWA TOEP C730600 0EA Modbus TCP/IP Installation Manual
Figure 5.24 Connect the Ground Wire
C - Ground wire
D - Stud
5 Installation Procedure
39