YASKAWA SI-EM3D Installation Manual page 22

5 Installation Procedure
A - Route wires through the openings
provided on the left side of the
front cover.
If there is wiring outside the enclosure, the drive will not meet Enclosed wall-mounted
*1
type (IP20/UL Type 1) requirements.
6.
Firmly connect the Ethernet communication cable to the option modular
connector CN1 port 1 or port 2.
Isolate communication cables from main circuit wiring and other electrical and
power lines. Make sure that you firmly connect the cable end. (Refer to
5.28). Refer to
information.
NOTICE
you observe correct electrostatic discharge (ESD) procedures. If you do not follow
procedures, it can cause ESD damage to the drive circuitry.
7.
Reattach the front cover (A), terminal cover (C), and keypad (B).
Refer to the drive manuals for more information.
22
*1
Figure 5.6 Wire Routing Examples
Communication Cable Specifications on page 42
Damage to Equipment. When you touch the option, make sure that
YASKAWA TOEP C730600 0EA Modbus TCP/IP Installation Manual
B - Use the open space provided
inside the drive to route option
wiring.
Figure
for more