Table of Contents
Advertisement
1.
Remove the keypad (B), front cover (A), and terminal cover (C).
Shut off power to the drive and wait for the time specified on the drive warning
label at a minimum. Make sure that the charge indicator LED is unlit, then remove
the keypad and front cover. Refer to the drive manuals for more information.
You can only install this option into the CN5-A connector on the drive control
board.
NOTICE
you observe correct electrostatic discharge (ESD) procedures. If you do not follow
procedures, it can cause ESD damage to the drive circuitry.
A - Drive front cover
B - Keypad
Figure 5.2 Remove the Keypad, Front Cover, and Terminal Cover
YASKAWA TOEP C730600 0EA Modbus TCP/IP Installation Manual
Damage to Equipment. When you touch the option, make sure that
C - Drive terminal cover
5 Installation Procedure
19
Advertisement
Table of Contents
