Table of Contents
Advertisement
5 Installation Procedure
A - Insertion point for CN5 connector
B - Option
C - Drive front cover
D - Keypad
E - LED label
F - Drive terminal cover
G - Removable tabs for wire routing
H - Included screws
Install the Option
Use this procedure to install the option.
DANGER
energized drive. Before servicing, disconnect all power to the equipment and wait for the time specified on
the warning label at a minimum. The internal capacitor stays charged after the drive is de-energized. The
charge indicator LED extinguishes when the DC bus voltage decreases below 50 Vdc. When all indicators
are OFF, measure for dangerous voltages to make sure that the drive is safe. If you do work on the drive
when it is energized, it will cause serious injury or death from electrical shock.
18
Figure 5.1 Drive Components with Option
Electrical Shock Hazard. Do not examine, connect, or disconnect wiring on an
I -
Ground wire
J -
Option modular connector CN1
port 1 (RJ45)
K - Option modular connector CN1
port 2 (RJ45)
L - Drive grounding terminal (FE)
M - Connector CN5-A
N - Connector CN5-B (Not available
for communication option
installation.)
O - Connector CN5-C (Not available
for communication option
installation.)
YASKAWA TOEP C730600 0EA Modbus TCP/IP Installation Manual
Advertisement
Table of Contents
