Table of Contents
Advertisement
COM 1 3f8
COM 2 2f8
and /w activates the Wizard mode, in which PORTWIZ edits the auto-
exec.bat and system.ini files for you. Remember that you can type a
command line with or without spaces, however it cannot exceed 255
characters (including spaces).
Examples:
1.
To configure the TA to COM 4 with interrupt 10 and to have
PORTWIZ edit your autoexec.bat and system.ini files for you,
type:
and press Enter. The /w activated the Wizard mode, which
handles the file changes automatically.
2.
To configure the TA the same way but not edit your autoexe.bat
and system.ini files, type:
and press Enter. If this combination works, then put this line in
your autoexec.bat file and remember to edit the [386Enh] sec-
tion of your system.ini file as well. Add the lines:
You do not need to reboot in order to start using your TA im-
mediately in either DOS or Windows.
3.
If you are unsure of which IRQ to use, you can instruct
PORTWIZ to try a series of IRQs in sequence. Use only IRQs
12, 11, 10, 7, 5, 4 and 3 in that order. You may specify any or
all of them in this example. You also may use the /w switch to
activate the Wizard mode.
To set the TA to COM 2 and test IRQs 12, 11, 7, and 5 in the
Wizard mode, type:
and press Enter. Note there are no commas, but the spaces are
required.
4.
If you type:
Chapter 2 Installation
COM 3 3e8
COM 4 2e8
PORTWIZ 2e8 10 /w
PORTWIZ 2e8 10
COM3Base=2e8h
COM3Irq=10
PORTWIZ 2f8 12 11 7 5 /w
PORTWIZ
21
Advertisement
Table of Contents
Need help?
Do you have a question about the ISDN TA and is the answer not in the manual?
Questions and answers