Setting Up In Windows 95 - Zoom ISDN TA Owner's Manual

To attach the handset hook and cord retainer, peel the protective
paper off the adhesive backs and press them to one side of your
monitor. Be sure to align the the bottom of the hook horizontally with
your desk's surface so that the handset hangs straight down.
You are now ready to configure the ISDN TA using the included soft-
ware. Depending on the version of the Windows operating system you
are running, go to the appropriate setup section that follows.

Setting Up in Windows 95

This section is for Windows 95. If you have Windows 3.1 or 3.11,
please go to page 19. If you have Windows NT, please go to page 22.
The Plug and Play feature of the Windows 95 operating system auto-
matically detects your ISDN TA and allocates hardware resources with
no need for you to set a COM port or IRQ setting.
To complete configuration, follow these steps:
1. Turn your computer on.
2. As the Windows 95 operating system starts up, a New Hard-
ware Found box is displayed. The first line of this box should
show the name of this product.
3. In the New Hardware Found box, there are three choices for
installing a "driver." The default is for the driver to be installed
from a disk provided by the hardware manufacturer. Make sure
this choice is highlighted and click OK.
Chapter 2 Installation 15