Throttle Trigger/Interlock Lever - Stihl SR 430 Manual

8.3 Throttle Trigger/Interlock
Lever
1
: Take out the screws (arrows).
– Remove the handle molding (1).
The cam may fall out.
Version with throttle limiter
1
2
: Carefully remove the setting
lever (1) – tension of torsion
spring (2) is suddenly relieved.
– Remove the torsion spring (2).
52
Version with throttle lock
1
: Remove the cover (1).
Both versions
: Pull off the cam (1).
2
: Pull the detent spring (1) slightly
apart and lift it out over the
guides (arrows)
– do not overstretch the detent
spring.
– Check the cam (2) and detent
spring (1) and replace if
necessary
: Push the detent spring (1) into
the guides (arrow) until it snaps
into position
– do not overstretch the detent
spring.
1
1
: Disconnect the leg (arrow) from
the lever (1).
– Remove the torsion spring (2).
2
1
3
1
: Remove the throttle trigger (1)
and lever (2).
– Disconnect the throttle cable (3).
1
2
SR 430, SR 450