Stihl SR 430 Manual page 98

1
– Check the outer blower
housing (1) and replace it if
necessary
– Inspect other components and
transfer if necessary.
– Transfer the pressure pump (if
fitted), b 10.5
– Transfer the AV springs, b 7
1
: Pull out the air guide (1).
SR 430, SR 450
Installing
1
: Position the air guide (1) on the
guides (arrows) and push it
home.
1
: Place the elbow (1) in position.
1
– Place the outer blower
housing (1) in position.
: Insert the screws (arrows) and
tighten them down firmly.
1
3
– Fit the antistatic wire (2) and
chain (3).
: Insert and tighten down the
screw (1) firmly.
1
: Fit the hose (1) in the
guide (arrow).
1
: Push the gasket (1) fully home –
its lips must locate snugly against
the housing.
2
97