Stihl SR 430 Manual page 38

: Fit the ground and short circuit
wires in the guides (arrows).
1
: Push the protective tube (1) into
its seat (arrow) in the handle
molding.
: Push the wires (short circuit wire
first) into the guide (arrows)
– position the wires parallel
without loops.
SR 430, SR 450
1
: Push the throttle cable (1) into its
seat (arrow).
– Install the valve, b 10.9.2
– Install the control levers and cam,
b 8
1
– Fit the handle molding (1) in
position.
: Insert the screws (arrows) and
tighten them down firmly.
3
2
– Position the protective tube (1)
so that the throttle cable (2) is
under the wiring harness (3) in
the direction of the blower
housing.
: Push the protective tube (1) into
its guides (arrows) as far as stop.
– The protective tube is now held
in position.
1
: Attach the throttle cable (1) to the
carburetor (2).
1
: Push the throttle cable (1) into
the guides (arrows).
– Check operation of throttle cable
and readjust if necessary,
1
b 9.8.1
1
2
37