Stihl SR 430 Manual page 29

2
: Attach the snap ring (1) to the
magnet (2) so that the snap ring
gap is on the flat side of the tool's
shank (arrow).
2 1
: Push the large slotted diameter of
the sleeve 5910 893 1706 over
the magnet and snap ring.
The inner pin (1) must point towards
the flat face (2) of the tool's shank.
28
1
: Press the installing tool
downwards into the sleeve until
the magnet butts against the end
of the guide slot.
Use a suitable base (wooden
board).
: Remove the sleeve and push it
on to the other end of the shank
as far as stop.
The inner pin (arrow) must again
point towards the flat face.
– Install the snap ring at the blower
side of the piston.
: Apply the installing tool
5910 890 2212 with the sleeve's
taper against the piston boss,
hold the piston steady, center the
tool shank exactly and press
home until the snap ring slips into
the groove.
Make sure the tool shank is held
square on the piston pin axis.
1
Fit the snap ring (1) so that its
gap (arrow) points down – it must
not be near the recess (2).
– Check installed position of snap
ring.
SR 430, SR 450
2