Installing
Make sure the protective tube is
properly seated.
1
: Place the shroud with the
contour (arrow) against the
engine pan (1) and push it into
position.
2
: Push the stop buffer (1) onto the
tapered pin (2).
20
1
: Push home the shroud (1) until it
is properly seated.
: The air guide shroud must
engage the guide (arrow).
: Insert the screws (arrows) and
tighten them down firmly.
1
1
: Tighten down the screw (1)
firmly.
4.5
Engine
– Troubleshooting, b 3.5
The complete engine has to be
removed for access to the piston,
cylinder and crankshaft.
– Remove the air guide shroud,
b 9.3
2
1
: Disconnect the short circuit
wire (1) and ground wire (2).
– Put the wires to one side.
SR 430, SR 450