Stihl SR 430 Manual page 32

1
3
: Take out the screw (3) and
washer.
– Remove the connector tag (1).
: Take out the screw (2) and
washer.
1
: Remove the ignition module (1).
1
The ignition module (1) and ignition
lead (2) form a unit.
– Check the spark plug boot and
replace if necessary, b 5.4
– Troubleshooting, b 3.3
SR 430, SR 450
Installing
2
: Hold the wiring harness (1) in the
direction of the carburetor so that
it cannot be pinched.
: Position the ignition module (1)
so that the ignition lead (2) points
towards the carburetor.
: Fit the screw (3) with washer – do
not tighten down yet.
2
1
2 1
3
1
: Fit the connector tag (1) and
insert the screw (2) with washer
– do not tighten down yet.
1
– Push the ignition module (1)
back.
: Slide the setting gauge (2)
4118 890 6401 between the
arms of the ignition module and
the flywheel magnet.
2
2
31