Stihl SR 430 Manual page 87

1
: Fit the gasket (1) into the
groove (arrow).
: On the underside, engage the
cutouts in the gasket over the
lugs (arrows).
2
3
– Hold the rotary shutter with the
toothed pivot pin (1)
pointing in the direction of
the anti-vibration spring (2).
: Fit the rotary shutter (3) in
the hole (arrow).
86
1
: Push the pivot pin (1) into the
hole (arrow).
: Fit the lever (1) into the hole so
that it engages the teeth.
– Push the lever (1) fully home.
– Check operation
– the rotary shutter must open
and close when the lever is
turned.
1
1
: Insert and tighten down the
screw (1) firmly.
1
– Install the cable, b 10.4
– Make sure that the
gasket (1) is properly
seated.
1
1
– Position the metering unit (1) with
AV springs in the seats and push
it into place.
: Push the clamping strap (2) into
place.
: Insert the screws (arrows) and
tighten them down firmly.
2
SR 430, SR 450