Stihl SR 430 Manual page 61

: Take out the screw (1).
1
: Take out the screw (1).
1
2
: Hold the carburetor (1) steady,
grip the upper edge of the filter
housing (2) and pull it off the
studs – disconnect the rubber
grommet if necessary.
– Remove the fuel hoses from the
lower guides at the same time.
60
1
1
: Pull the filter housing (1) off the
boss (arrow).
1
: Remove the gasket (1).
: Check and clean the sealing
faces (arrows) on the carburetor
and filter housing, b 13
Always replace components with
damaged sealing faces.
1
: Push out the grommet, (1).
– Check the gasket (1)
and replace if necessary.
Make sure the gasket (1) is properly
seated.
Installing
1
: Fit the gasket (1).
SR 430, SR 450
1