Stihl SR 430 Manual page 54

2
1 1
: Pull the lever (1) off the throttle
trigger (2).
Installing
1
– Check that the grub screw (1) is
in place, fit a new grub screw if
necessary.
A new throttle trigger comes with
the grub screw already fitted.
– The throttle cable must be
readjusted if a new throttle trigger
is installed or the position of the
grub screw is changed, b 9.8.1
SR 430, SR 450
2
The ground and short circuit wires
must be properly seated in the
guides (arrows).
1
1
: Push the lever (1) into the throttle
trigger so that it fits snugly
against the throttle trigger
(arrow).
1
: Push the throttle cable nipple (1)
into the lever and engage it in the
slot (arrow).
Version with throttle limiter
: Push the throttle trigger (1) onto
Version with throttle lock
1
: Push the throttle trigger (1) onto
Both versions
: Fit the torsion spring (1) on the
the pivot pin.
the pivot pin.
throttle trigger and position its
short leg against the web (arrow).
1
1
1
53