Special Servicing Tools - Stihl SR 430 Manual

12.

Special Servicing Tools

New Special Tools
No. Description
1 Clamping strap
Existing Special Tools
No. Description
1 Pump
2 Sealing plate
- Hose for leakage test
- Nipple
3 Locking strip
4 Screwdriver bit, T 27 x 125
5 Threaded bushing
6 Assembly drift
7 Installing sleeve
8 Setting gauge
9 Combination wrench
10 Test flange
11 Ignition system tester, ZAT 4
12 Ignition system tester, ZAT 3
13 Torque wrench
14 Torque wrench
15 Installing tool 12
16 Screwdriver
- Setting disk
17 Screwdriver Q-SW 8x200
18 Screwdriver bit, T 27 x 200
19 Puller
20 Crimping tool
21 Puller
22 Sleeve
23 Socket DIN 3124, 13 mm
SR 430, SR 450
Part No. Application
4244 893 2600 Installing the piston
Part No. Application
0000 850 1300 Testing engine and carburetor for leaks
0000 855 8106 Sealing the exhaust port
1110 141 8600 Testing carburetor for leaks
0000 855 9200 Testing carburetor for leaks
0000 893 5904 Blocking the crankshaft
0812 542 2104 Removing and installing spline socket
(IS) screws with electric or pneumatic
screwdrivers; tightening down screws
with torque wrench
1108 893 4500 Holding engine pan with puller
5910 890 4400
1108 893 4700 Removing and installing piston pin
1118 893 4602 Protects oil seal at fan side
4118 890 6401 Adjusting air gap between the ignition
module and flywheel
4119 890 3400 Releasing nuts and screws
5910 850 4200 Leakage Test
5910 850 4503 Testing ignition system
5910 850 4520 Testing ignition system
5910 890 0302 0.5 to 18 Nm
5910 890 0312 6 to 80 Nm
5910 890 2212 Installing hookless snap ring in piston
5910 890 2305 Adjusting carburetor
5910 893 6600 Add-on for screwdriver (adjusting
carburetor)
5910 890 2420 Carburetor nuts
5910 890 2415 IS-P screws (4 mm)
5910 890 4501 Removing limiter caps
5910 890 8210 Attaching connectors to electrical wires
5910 893 0801 Releasing flywheel
5910 893 1706 Sleeve for installing tool 12
5910 893 5608 Removing flywheel nut
Rem.
1)
Rem.
1)
1)
1)
1)
1)
107