Advertisement
4. Secure each knife to the knife mount using (3) 1/2" lock washers, a 1/2" flat washer, a 1/2"-13 hex nut, a 1/2"-13
x 1-3/4" hex bolt, and a 1/2"-13 x 1-1/4" hex bolt. The shorter bolt is used towards the top of the knife and is
threaded into the mount. The longer bolt is used towards the bottom of the knife and is secured using the hex
nut. Ensure to mount the knife in line with the coulter. Use a shim to adjust the knife out to keep it aligned
with the coulter, if necessary.
5. Slide gauge wheel assembly into gauge wheel mount and insert pin. Mount tire onto studs and secure with
1/2"-20 lug nuts.
6. Route fertilizer hoses around frame and connect to each coulter.
Coulter and Wheel Finishing
Shims go here
if necessary
29
Advertisement
