Advertisement
1. Set up main toolbar with the front section level and the back section elevated slightly.
2. Mount down pressure cylinder linkage plates and center down pressure cylinder to the front section with pins.
3. Mount the 4" x 24" wing cylinders. Use a block to support the cylinders. When mounting the cylinders, ensure
the bolt on the ram side of the cylinder is facing up and the hydraulic fittings face towards the rear of the
toolbar. Two sizes of pins hold these cylinders in place. The rod section of the cylinder which faces towards
the outside of the applicator uses a 1" x 3-5/8" pin. The section of the cylinder which faces the inside of the
applicator uses a 1" x 3-3/8" pin.
16
Toolbar
Bolt on top of cylinder
Hydraulic fittings towards rear
Advertisement
