Advertisement
18. Mount the ball valve to the mount plate to rear driver's side of applicator using 1/2" x 1-3/4" hex bolts and 1/2"
serrated flange hex nuts. A wire hangs on the cap of the valve. Before fastening the bolts with the nuts, loop
one eyelet of the wires over the inside of the bolt and slide a washer in behind it (as shown below). Thread
both nuts onto the bolts and tighten.
19. Connect tank shut off valve to fill valve with 2" x 40" hose. Connect tank shut off valve to pump using same
length hose as above. Clamp down hoses.
14
Tank
Advertisement
