Advertisement
Front view
23 coulters
50cm row spacing
9
8
10
11
12
1. Fasten the first coulter in the center of the main toolbar. Measure 50cm on each side to place the next coulter
and repeat for all 23 coulters. Mount coulters on the main toolbar towards the front and mount coulters on
the wings toward the back (as shown in the picture above).
2. To mount the coulters, place (2) 5/8"-11 x 7-1/8" x 10-1/4" Square
U-bolts facing outward as shown above.
3. Slide the channel bracket plate onto the U-bolts.
4. Set the channel bracket castings onto the U-bolts behind the
channel bracket plate. Thread (4) 5/8" serrated flange nuts onto the
U-bolts but leave the nuts loose.
5. Slide the coulter rod, roll pin, and QJ mounting pad down between
the plate and the casting.
6. Make sure the depression for square head bolt is facing forward
(shown on right).
22
Coulter Mounting - 50cm Row Spacing
6
5
3
4
7
50cm
2
Place coulter 2
here.
Start coulter 1
in the middle
of the main
toolbar
4
3
2
1
2
Center line
50cm
Place coulter 2
here.
Channel
1
bracket
Offset coulter
mounts are
shown in red.
9
6
8
7
5
50cm
3
2
Place coulter 3
here.
casting
Channel
bracket
plate
Depression
for square
head bolt
12
11
10
QJ mounting
pad
Coulter
rod
Advertisement
