Advertisement
1. Hook chains on each side of axle through the provided hole. Wrap an 8,000 lb stap around the neck of the
tongue. Find the right length to pick it up evenly so the load is balanced. Lift slowly over the toolbar and
center into position while lowering slowly.
Use this hole in the
axle to hook up
chain for lifting.
2. Align the holes in the middle toolbar with holes in the axle. Use the 2-1/2" x 10-1/2" pivot pin and secure with
3/4" x 2-1/2" bolt and 3/4" centerlock hex nut. Insert bolt from the inside out so that the nut is on the outside.
3. Leave chains attached so it is easier to mount the wheels.
4. Mount the gauge wheel mounts to the toolbar. Place the mounts to the outside of the outer most coulter on
the wings. The gauge wheel mounts face the front of the wing which is opposite of the coulters (as shown
below).
26
Connecting Frame and Coulters to Toolbar
Use wrap to lift
around the "neck"
of the tongue.
Advertisement
