Advertisement
9. Bolt on light bars using 1/2" x 2-1/4" bolts and 1/2" centerlock hex nut. Use the outside holes in the frame when
mounting the light bars.
10. Secure rear lights onto the light bars with 1/4" x 3/4" bolts and 1/4" serrated flange nuts. Red lights face out
from the applicator are located closer to the inside of the applicator and yellow lights are located closer to the
outside.
11. Guide the rear light harness through the conduit on the inside of the rear applicator frame. Guide the end of
wire harness that is labeled "Left" through the conduit towards the left (driver's side) light bar. Push the end of
the harness that is labeled "Right" through the light bar on the right (passenger's) side.
12. Prep the front hydraulic hose guard by attaching the pressure gauge and down pressure relief valve bank.
6
Frame
Advertisement
