Advertisement
4. Die grind the paint off the inside of the holes on the toolbar and the wing extensions that will have pins
inserted into them (as shown below). Die grinding makes inserting the pins easier.
5. Mount wing extensions. Start on the right side of the toolbar. Using a lift, align the holes of the wing
extension with the holes in the toolbar. (Left and right wings are different, make sure you have the correct
one.)
6. Insert the 2-1/2" diameter pivot pins. Set the bolt-mounted D-ring over the pivot pin so that it covers the
retainer and the hole on the D-ring lines up with the hole on the pivot pin. Fasten with the bolt facing upward
so the nut is on top of the toolbar (as shown below).
7. Repeat the wing extension mounting procedures for the left side.
8. Install transport latches to each side of the toolbar as shown below and secure with pins (as shown below).
9. Add hydraulic fittings to cylinders. Refer to Hydraulic Fittings (Schematic) in the Operator's Manual.
Toolbar
17
Advertisement
