Table of Contents
Advertisement
When connecting hydraulic hoses to moving
parts, the length of the hose must be dimen-
sioned in such a way that over the total move-
ment range the bending range is not lower
than permitted and/or the hydraulic hose is not
subjected to tensile loads.
54
NOTE
Storage
Clean the machine thoroughly. Chaff and dirt
¾
will attract moisture, which causes corrosion.
Park the machine indoors and secure it with
¾
wheel chocks against rolling away.
Protect the machine against corrosion. Use
¾
only biodegradable oils for anti-rust spraying.
Do not spray the plastic and rubber parts with
¾
oil or corrosion protection agent. These parts
could become brittle and break.
At the end of the season
If a high pressure cleaner is used for cleaning,
do not direct the water jet to bearings, electrics/
electronic components and sensitive cover
panels.
Clean the filter insert.
¾
Lubricate the machine according to the lubri-
¾
cation plan.
Grease the visible threads of setscrews and
¾
similar.
Wet all lever joints and bearing points, which
¾
are not subjected to lubrication, slightly with
oil.
Make a note of all service and maintenance work
that has to be done before the start of the next
season and place a corresponding order with
your HORSCH sales partner in due time. Your
HORSCH sales partner will be in a much better
position to execute the maintenance service and
possibly necessary repairs outside the season.
NOTE
NOTE
NOTE
Advertisement
Table of Contents
