Table of Contents
Advertisement
High pressure cleaner
Do not clean new machines with a steam jet
or high pressure cleaner.
The paint takes approx. 3 months to cure and
could be damaged before this time.
Remember the following points when cleaning
with a high pressure cleaner/steam jet:
Do not clean any electrical components.
¾
Do not clean any chrome-plated components.
¾
Before cleaning the machine cover all open-
¾
ings, which should stay clear of water, steam
or cleaning agents for reasons of safety or
functioning.
Do not aim the water jet directly at electrical
¾
or electronic components and bearings.
Do not direct the cleaning jet of the high pres-
¾
sure cleaner/steam jet directly on lubrication
points and bearings, lines and stickers.
Always keep a minimum distance of 300 mm
¾
between cleaning nozzle and machine.
Avoid the use of dirt removing tools on the
¾
high pressure cleaner, if necessary, keep a
greater distance.
Pay attention to the safety regulations when
¾
using high pressure cleaners.
CAUTION
Risk of fluids escaping under pressure.
The external cleaning system may be contami-
nated with spraying mixture deposits!
Secure the washing gun with the lock against
accidental spraying:
before each spraying pause
¾
before the washing gun is stored again in its
¾
holder after cleaning is finished.
NOTE
The Shuttle is equipped with a high pressure
cleaner (optional) that can be used to clean the
machine.
The high pressure cleaner is powered hydrauli-
cally and supplied from the fresh water tank
(Tank 2).
3
1
High pressure cleaner
1 Hose reel
2 Pressure hose
3 Washing gun
1. Close valve 3.
2. Open valve 4.
3. Turn the lever 6 down to high pressure cleaner.
Water is suctioned from the fresh water tank.
4. Pull the pressure hose off the reel and clean
the machine with the washing gun.
Water escapes from the washing gun as
¾
long as the handle is pressed.
To fix the handle actuation press the tappet
¾
during operation.
Press the handle to release.
¾
After switching off relieve the residual
¾
pressure.
5. After cleaning is completed, turn lever 6 to
the centre position to turn off the pump again.
6. Close valve 4.
7. Wind up the pressure hose again on the reel
and place the washing gun on the bracket.
2
45
Advertisement
Table of Contents
