Table of Contents
Advertisement
Care and
maintenance
WARNING
Danger of crushing, shearing, cutting,
cutting off, being caught, wound up, pulled
in, caught and knocked by accidental
starting and rolling away of the machine.
Secure the machine against accidental starting
and unintended rolling before you start care,
service or maintenance work on the machine.
WARNING
Danger of crushing, shearing, cutting, cut-
ting off, being caught, winding up, being
pulled in and impact caused by unprotected
danger spots!
Reattach all protective features that were
¾
removed for the purpose of care, service and
maintenance work on the machine.
Replace defective protective features with
¾
new ones. Use only HORSCH original parts.
DANGER
Observe all safety notes when carrying out
¾
care, service and maintenance work!
Regular and proper maintenance will keep the
¾
machine for a long time in an operable state
and prevents premature wear.
NOTE
Your machine has been designed and built to
offer maximum performance, economy and
operator friendliness under a vast variety of
operating conditions.
Before delivery the machine was inspected at
the factory and by your dealer to make sure
that it is in optimal condition. For trouble-free
operation it is very important to carry out the
necessary work for care and maintenance at
the recommended intervals.
Ensure that regular tests and inspections are
¾
always carried out to schedule as specified in
the operating instructions.
Service and maintain the carrier vehicle
¾
according to the manufacturer's requirements.
Pay attention to the operating instructions of the
carrier vehicle.
For service and maintenance work park the
¾
machine on level and solid ground, secure it
against rolling away.
Use only spare parts approved by HORSCH.
¾
Use only spare hoses approved by HORSCH
¾
and always use hose clamps made of stain-
less steel for assembly.
When performing care and maintenance work
¾
pay attention to environmental protection
measures.
Strictly comply with the statutory regulations
¾
for the waste disposal of operating materials,
such as oils and greases. These statutory
regulations also apply to parts coming into
contact with such operating materials.
When lubricating with high pressure grease
¾
guns do not exceed the lubrication pressure
of 400 bar.
Initiate protective measures (e.g. cover or
¾
even disassemble lines at particularly critical
points)
when welding, drilling or grinding
•
when working with abrasive cutting wheels
•
in the vicinity of plastic hoses and electric
lines.
Thoroughly clean the machine before each
¾
repair or maintenance, especially the parts
contaminated by the spraying mixture.
47
Advertisement
Table of Contents
