Table of Contents
Advertisement
Flushing in preparations
Illuviation valve
DANGER
Wear appropriate protective outfit for the illuvi-
ation of the preparations.
Observe the regulations and notes of the crop
protection manufacturer!
Crop protection agent and carbonyl diamide are
poured into the illuviation valve, dissolved and
drawn in.
Swing the illuviation valve down by pulling it by
the handle.
Flush the respective preparation through the
illuviation valve into the water of the spraying
mixture container. A difference is in this case
made between the illuviation of fluid and pow-
dery preparations or carbonyl diamide.
Care must be taken when cleaning the illuviation
valve that no undesirable point-type entries of
preparations are generated!
B
A
Pump and operating elements
E
D
Fitting on the illuviation valve
40
NOTE
C
G
F
Fitting
A Main filling valve
B Fitting valve
C Lever for speed control of the delivery pump
D Activate/deactivate rinsing nozzles
E Activate/deactivate shock nozzle
F Activate/deactivate washing gun
G Activate/deactivate canister flushing
1 Fresh water filling hose connection (Camlock)
2 Fresh water tank (Tank 1- 200 litres)
3 Filling on/off
4 Fresh water tank (Tank 2- 800 litres)
5 Internal tank cleaning / illuviation valve
6 Fresh water pump operation
7 Delivery pump operation
Flushing in liquid preparations
1. Close valve A.
2. Open valve B.
3. Close valve 3.
4. Open valve 4.
5. Turn the lever 6 up to fresh water pump. Water
is suctioned from the fresh water tank.
6. Set valve 5 to illuviation valve.
7. Open the lid of the illuviation valve.
8. Fill the preparation quantity calculated and
measured for filling the tank into the illuvia-
tion valve.
9. Turn the lever 7 up to Suction to flush the con-
tent of the illuviation valve into the spraying
mixture container. Control the pump speed
with lever C.
10. Turn the switch-over ball valve of the illuvia-
tion valve to the position for sucking-off. Let
the content be fully sucked off.
6
7
4
2
3
5
1
Advertisement
Table of Contents
