Information Messages - Husqvarna AUTOMOWER 310 Operator's Manual

6.3 Information messages

The information messages in the table below are shown in the display of the product. Speak to your Husqvarna
representative if the same message shows frequently.
Message Cause
Low battery
The product cannot find the charging station.
The battery is at the end of its life cycle.
The antenna of the charging station is defec-
tive.
The charging plates on the product or con-
tact plates on the charging station are defec-
tive because of corrosion.
Settings restored Reset all user settings has been done.
A
Guide not found
The guide wire is not connected to the charg-
ing station.
Damage in the guide wire.
The guide wire is not connected to the boun-
dary loop.
Guide calibration
The product has not calibrated the guide wire
failed
because of an error.
Guide calibration
The product has calibrated the guide wire.
done
Connection changed
New loop signal changed.
1440 - 004 - 24.03.2021
Action
Change the position of the guide wire. Refer
To install the guide wire on page 20 .
to
Replace the battery. Refer to
page 36 .
Do a check if the indicator lamp in the charg-
ing station flashes red. Refer to
lamp in the charging station on page 42 .
Clean the charging and contact plates using
a fine grade emery cloth. If the problem stays
speak to your approved servicing dealer.
Usual operation of the product.
Connect the guide wire to the charging sta-
To install the guide wire on
tion. Refer to
page 20 .
Replace the damaged section with new
guide wire.
Connect the guide wire correctly to the boun-
To install the boundary
dary loop. Refer to
wire on page 20 .
Install the guide wire correctly. Refer to
install the guide wire on page 20 .
Usual operation of the product.
Usual operation of the product.
Troubleshooting - 41
Battery on
Indicator
To