Installation Of The Product - Husqvarna AUTOMOWER 310 Operator's Manual

• If the work area includes a secondary area (D),
refer to To make a secondary area on page 18 .
Put the product in the secondary area and select
Secondary area mode .
D
B

3.5 Installation of the product

3.5.1 Installation tools
• Hammer/plastic mallet: To simplify putting the
stakes into the ground.
• Edge cutter/straight spade: To bury the boundary
wire.
• Combination pliers: For cutting the boundary wire
and pressing the connectors together.
• Adjustable plier: For pressing the couplers
together.
3.5.2 To install the charging station
WARNING:
about electrical safety.
WARNING:
used with the power supply unit supplied by
Husqvarna.
1440 - 004 - 24.03.2021
A
C
Obey national regulations
The product is only to be
WARNING:
supply at a height where there is a risk it can
be put in water. Do not put the power supply
on the ground.
WARNING:
power supply. Condensed water can harm
the power supply and increase the risk of
electrical shock.
WARNING:
Install only to an residual-current device
(RCD) with a tripping current of maximum 30
mA when connecting the power supply to
the power outlet. Applicable to USA/Canada.
If power supply is installed outdoors: Risk of
Electric Shock. Install only to a covered
Class A GFCI receptacle (residual-current
device) that has an enclosure that is
weatherproof with the attachment plug cap
inserted or removed.
CAUTION:
Do not make new holes in
the charging station plate.
CAUTION:
Do not put your feet on the
baseplate of the charging station.
WARNING:
and the extension cable must be outside the
work area to avoid damage to the cables.
When connecting the power supply, only use a power
outlet that is connected to an residual-current (RCD)
device.
1. Read and understand the instructions about the
charging station. Refer to
the charging station on page 14 .
2. Put the charging station in the selected area.
Note:
Do not attach the charging station to the
ground with the screws until the guide wire is
To install the guide wire on page
installed. Refer to
20 .
3. Connect the low-voltage cable to the charging
station.
4. Put the power supply at a minimum height of 30
cm / 12 in.
Do not put the power
Do not encapsulate the
Risk of Electric Shock.
The power supply cable
To examine where to put
Installation - 19