Information Messages - Husqvarna AUTOMOWER 320 NERA Operator's Manual

7.3 Information messages

The table below shows information messages that can be found in the
Connect app and in Automower
frequently.
Message
Limited cutting height The cutting height adjustment cannot move.
Unexpected cutting
height adj
Limited cutting height
range
Cutting height prob-
lem
Cutting system imbal-
ance
Guide 1 not found
Guide 2 not found
Guide 3 not found
GPS navigation prob-
lem
Weak GPS signal
36 - Troubleshooting
®
Access. Speak to your local Husqvarna representative if the same message shows
Cause
The product has discovered vibrations in the
blade disc.
The guide wire you have installed before is
not found.
Problem with the GPS assisted navigation
equipment.
The GPS signal is blocked in large parts of
the work area.
Messages menu in the Automower
Action
Examine the cutting height adjustment and
remove grass or other objects. If the problem
stays, speak to your approved servicing deal-
er.
Make sure that the blades and screws are
not damaged and worn. Make sure that all
blades are correctly installed and that there
is only one blade attached in each position
on the blade disc. Clean the blades and the
cutting disc.
Examine if the guide wire is not correctly
connected to the charging station or the
boundary wire. Examine if there is a break
in the guide wire. Refer to
the loop wire on page 38 .
Restart the product. If the problem stays,
speak to your authorized service center.
If possible, remove objects that can cause a
blockage of the GPS signal.
Disable the GPS navigation function and use
the lawn coverage function. Refer to
assisted navigation on page 22 .
2071 - 001 - 29.03.2023
®
Finding breaks in
GPS