Husqvarna AUTOMOWER 310 Operator's Manual page 28

Note:
It is usually better to move the charging station,
than to decrease the range of the charging station
signal.
3.12.7.3 Corridor width
The boundary wire corridor is the area adjacent to the
boundary wire and the guide corridor is the area
adjacent to the guide wire. The product uses the
corridors to find the charging station. When the product
moves in the direction of the charging station, it always
moves to the left of the guide wire.
The corridor width is adjusted automatically. If it is
necessary to adjust the corridor width manually for the
product to operate satisfactorily, you can set the corridor
width between 0-9. If guide corridor width is set to 0, the
product straddles the guide wire. The factory setting is 6
for the boundary wire and 9 for the guide wire.
To set the corridor width
1. Do steps 1–3 in To get access to the menu in the
display of the product on page 23 .
2. Use the arrow buttons and the OK button to move
through the menu structure
> Corridor width .
3. Use the arrow buttons to select a corridor.
4. Use the number buttons to select a corridor width
of 0-9.
Note:
Make the corridor width as wide as possible for
a minimum risk of lines in the lawn.
3.12.7.4 Exit angle
Lawn Coverage function is less than
If the sum of the
100%, the product sometimes starts to mow at the
charging station. The product moves away from the
charging station with an exit angle between 90°–270°.
The exit angles can be set to 1–2 exit sectors.
To set the exit angle
To get access to the menu in the
1. Do steps 1–3 in
display of the product on page 23 .
28 - Installation
2.
3.
4.
5.
6.
3.12.7.5 Reversing distance
The reversing distance makes the product move in
reverse for a set distance, before the product starts to
cut the lawn. The factory setting is 60 cm / 2 ft.
To set the reversing distance
1.
2.
3.
4.
3.12.7.6 Drive Past Wire function
The front of the product always moves past the
boundary wire by a specified distance. Then the product
moves rearward and changes direction. The factory
setting is 31 cm / 13 in. You can select a distance of
20-50 cm / 10-15 in.
Note:
the distance will change along the boundary wire in all
parts of the work area.
Installation > Advanced
To set the Drive Past Wire function
1.
2.
3.
4.
3.12.8 Settings
In settings you can change the general settings to your
product.
Use the arrow buttons and the OK button to move
through the menu structure Installation > Advanced
> Exit angles > Sector 1 .
Use the number buttons to set the angles in
degrees.
Push the down arrow button.
Use the number buttons to select how frequently
the product must use each sector. Set in
percentage.
Push the BACK button.
Do steps 1-3 in To get access to the menu in the
display of the product on page 23 .
Use the arrow button and the OK button to move
Installation > Advanced
through the menu structure
> Reversing distance .
Use the number buttons to set the distance.
Push the BACK button.
If you change the distance for
To get access to the menu in the
Do steps 1–3 in
display of the product on page 23 .
Use the arrow button and the OK button to move
Installation > Advanced
through the menu structure
> Drive Past Wire .
Use the number buttons to set the distance.
Push the BACK button.
1440 - 004 - 24.03.2021
Drive Past Wire ,