Husqvarna AUTOMOWER 310 Operator's Manual page 38

Message Cause
Wheel motor
Grass or other object is wrapped around the
blocked, left/right
drive wheel.
Wheel motor overloa-
ded, left/right
Wheel drive problem,
right/left
Cutting system Grass or other object is wrapped around the
blocked
drive wheel.
The blade disc lies in a pool of water.
The grass is too high.
Cutting system imbal-
Too few or too many blades.
ance
Trapped The product is stuck in a small area behind a
number of obstacles.
Outside working area The boundary wire connections to the charg-
ing station are crossed.
The boundary wire is too close to the edge of
the work area.
The work area slopes too much by the boun-
dary loop.
The boundary wire is laid in the wrong direc-
tion around an island.
Disturbances from metal objects (fences, re-
inforcement steel) or buried cables close by.
The product finds it hard to distinguish the
signal from another product installation close
by.
Empty battery
The product cannot find the charging station.
The battery is spent.
The charging station's antenna is defective.
The charging plates on the product or con-
tact plates on the charging station are corro-
ded.
38 - Troubleshooting
Action
Clean the wheels and around the wheels.
Clean the wheels and around the wheels.
Move the product and prevent the collection
of water in the work area.
Cut the grass before you install the product.
Make sure that the grass is maximum 10
cm / 3.9 in.
Do a check of the blades on the blade disc.
Check if there are any obstacles which make
it hard for the product to move on from this
location. Remove the obstacles or create an
island around the obstacles. Refer to
make an island on page 17 .
Check that the boundary wire is connected
correctly.
Check that the boundary wire has been laid
according to the instructions. Refer to
amine where to put the boundary wire on
page 15 .
Try moving the boundary wire.
Put the product in the charging station and
generate a new loop signal.
Change the position of the guide wire. Refer
To install the guide wire on page 20 .
to
Replace the battery. Refer to
page 36 .
Check if the indicator lamp in the charging
Indicator lamp in
station flashes red. Refer to
the charging station on page 42 .
Clean the charging and contact plates using
a fine grade emery cloth. If the problem stays
speak to your authorized service technician.
1440 - 004 - 24.03.2021
To
To ex-
Battery on