Output Timing Delays - Banner Q5X Series Instruction Manual

Q5X Laser Triangulation Sensor with Dual Mode for Jam Detection
Response Speed Response Speed in Sync Mode
50 ms

3.2.7 Output Timing Delays

Use this menu to select the output timing delay to be set. On and off delay timers can be used together. The default is no
delay.
• —No delay
• —Delay—enables the selection of on and off delay timers
• —One-shot—enables a one-shot, fixed output pulse duration
Output
OFF Delay
ON Delay
1-Shot
When one of the timing delay options is chosen, the sensor returns to the Setup menu and additional options become
available to set the parameter(s):
• —On delay
• —Off delay
• —One-shot delay timer
Note: For the one-shot delay timer:
• LO = On pulse when a target is detected inside of the switch point(s)
• DO = On pulse when a target is detected outside of the switch point(s)
Delay Timers
Use these menus to set the delay timers. These menus are available only if an output timing delay is selected.
For and , the default is 0.
For , the default is 10 milliseconds for all response speeds
Use and to scroll through the values. Millisecond values do not include the decimal point; seconds values include the
decimal point.
• 1 to 999 ms (when
• 1.0 to 90.0 s
16
Repeatability
100 ms 10 ms
D
D
D
Figure 18. Output Timing Delays
is selected, the 1 to 9 ms range is available for 3 and 5 ms response times)
www.bannerengineering.com - Tel: + 1 888 373 6767
Ambient Light Rejection
Enabled
D
D
Time
Excess Gain
ON
OFF
D
(D = 1ms - 90.0s)