Discrete Output Menu (Dx_Out); Two-Point Teach - Banner L-GAGE LE250 IO-Link Instruction Manual

3.5 Discrete Output Menu (Dx_OUT)

Use this menu to view or change
• Setpoints
• Midpoint
• Mode
• Timers
• Polarity
The menu options are identical for
D1_OUT and D2_OUT.

3.5.1 Two-Point TEACH

The TchSpt1 and TchSPt2 options teach the desired switch points. When using the buttons, the switch points can be taught
independently. Both values must be taught when using the remote input. The same TEACH menus exist for both the
D1_OUT and D2_OUT, but the switch points are set independently.
NOTE: When in Switch mode, use
Navigate: MENU > Dx_OUT > Tch2Pt > TchSPt1 and navigate: MENU > Dx_OUT > Tch2Pt > TchSPt2
Remote Input: Available
Button Instructions
1. Present the target.
Action
Present the target. The target must be within the sensor's range..
2. Access the TEACH mode and TEACH the sensor.
MENU D1_OUT
Select Menu Item
or
Press to Save Setting
Go Back to Parent Menu
or
Press and Hold to Go Back
to Run Mode
(in Swtch mode only)
(available only when
SPtRef Custom is
selected)
Figure 16. Discrete 1 Output Menu Map (Discrete 2 is identical)
TEACH Switch Point on page 17.
www.bannerengineering.com - Tel: 763.544.3164
®
L-GAGE LE250/550 IO-Link Laser Gauging Sensors
Tch2Pt TchSPt1
D1_OUT Tch2Pt
Tch2Pt TchSPt2
TchMid WndSize
D1_OUT TchMid
TchMid TchMdPt
TchMid Offset
AdjSPt1 100 mm
D1_OUT AdjSPt1
AdjSPt2 1000 mm
D1_OUT AdjSPt2
Mode Alarm
D1_OUT Mode
Mode Health
Mode Swtch
Mode Swtch
Mode Wnd
Mode Wnd
SPtRef Object
D1_OUT SPtRef
SPtRef Backgrnd
SPtRef Custom
Offset 0 mm
D1_OUT Offset
Timer OffDly
D1_OUT Timer
Timer Off1Sho
Timer OnDly
Timer On1Sho
Result
The target's distance measurement value
displays.
TchSPt1 100 mm
TchSPt2 1000 mm
WndSize 300 mm
TchMdPt 500 mm
Offset 0 mm
OffDly 0 ms
Off1Sho 0 ms
OnDly 0 ms
On1Sho 0 ms
13