Dynamic Background Suppression - Banner Q5X Series Instruction Manual

Q5X Laser Triangulation Sensor with Dual Mode for Jam Detection

3.6.2 Dynamic Background Suppression

Dynamic TEACH sets a single switch point during machine run conditions. Dynamic TEACH is recommended for
applications where a machine or process may not be stopped for teaching. The sensor takes multiple samples and the
switch point is set between the minimum and the maximum sampled distances.
2
Press and
Hold > 2s
Note: The sensor must be set to
indicators are amber to indicate Dynamic TEACH mode.
Note: To program the sensor using remote input, remote input must be enabled (
1. Present the target.
Method Action
Push Button
Present the first target. The sensor-to-target distance must be within the
sensor's range.
Remote Input
2. Start the TEACH mode.
Method Action
Push Button Press and hold TEACH for longer than 2 seconds.
Remote Input No action required.
3. Teach the sensor.
Method Action
Push Button Press TEACH to teach the target.
Remote Input Single-pulse the remote input.
4. Present the targets.
Method Action
Push Button
Present additional targets. The sensor-to-target distance must be within the
sensor's range.
Remote Input
24
3
Press to start
sampling
1
Figure 22. Dynamic Background Suppression
=
www.bannerengineering.com - Tel: + 1 888 373 6767
5
Press to stop
sampling
4
to use the following instructions. The FLO and RET
Result
The target's measurement value displays.
Result
the display. The FLO and RET indicators
flash.
N/A
Result
The sensor begins sampling target
distance information and
T
The FLO and RET indicators flash.
Result
The sensor continues to sample target
distance information and
The FLO and RET indicators flash.
Switch
Point
Value
= ).
and flash alternately on
and
flash alternately on the display.
and
flash alternately on the display.