Parameters For Next Maintenance Calculation; General Maintenance Settings; Maintenance Frequency; Maximum Bonus - Emerson Liebert iCOM Training And Service Manual

iCOM
Control Training and Service Manual
The control always takes the component with the most on/ off (cycling) as the
reference component, which asking for the nearest maintenance (example: if the
fan runs continuously, but the compressor switches on/off all the time, the next
maintenance will be calculated from the compressor).
Alarms or warnings (like clogged filter, high or low pressure, fans alarm etc.) will
decrease the time to next maintenance immediately to 0. If the alarm was reset,
the original situation will be displayed again, but the alarm will be counted in the
diagnostics window.
The display's main window provides information about the next maintenance:
a bar graph (graphical display screen) will fill in, as the next maintenance gets
closer (the width of the graph equals to the standard maintenance Interval (No, 1
through 12 times a year). The date of the next maintenance is also displayed.

Parameters for next Maintenance Calculation

General Maintenance Settings

Maintenance Frequency

Can be set for NO or 1 thru 12 times a year. NO means the maintenance
calculation program is disabled.

Maximum Bonus

This value increases the time to next maintenance if all components run in
optimum way (number of starts, average running time).
Maximum Penalty
This value decreases the time to next maintenance if some components run in
non-optimum way (number of starts, average running time).
Last Maintenance
This date can be will be set by the calculations and the service-engineer and can
be viewed by others.
Service Engineer
Name can be added or edited.
Reset
Resets the counters for all of the components (fans, compressors, etc.) to zero (0).
Starts new maintenance calculation (reset after maintenance is completed).
47