Emerson Liebert iCOM Training And Service Manual page 119

iCOM
Controls Training and Service Manual
Factory Settings Parameters, page 7 of 9
Menu
Line
A156 (Password)
A157 ANOUT1LO/HI (Analog Output 1 Low/High Limit)
A158 ANOUT2LO/HI (Analog Output 2 Low/High Limit)
A159 ANOUT3LO/HI (Analog Output 3 Low/High Limit)
A160 ANOUT4LO/HI (Analog Output 4 Low/High Limit)
A161 FS HE/HU (Fanspeed Heat/Hum)
A163 ANLOUT1 (Analog Output 1)
A164 ANLOUT2 (Analog Output 2)
A165 ANLOUT3 (Analog Output 3)
A166 ANLOUT4 (Analog Output 4)
Note: The Analog Outputs 1 – 4 can be labeled as follows:
3PACT (3P Valve), HW (Hot Water), HW175 (Hot Water 1.75), VSD (Var
SpeedDrive), COOL (Cooling), CV175 (Cooling CW/FC 1.75), COOL1 (Cooling 1),
COOL2 Cooling 2), HEAT (Heating), NO (not used), MBV1 (MBV1), MBV2
(MBV2), SCR (SCR), CONF (Configurable), ALBD1 (AlarmBoard 1), ALBD2
(AlarmBoard 2), ALBD3 (AlarmBoard 3).
ADVANCED MENU's Continued
Parameter
SMALL DISPLAY
(Large Display)
118
Control
Range Board
Safe
- -
0 – 100% CSF
0 – 100% CSF
0 – 100% CSF
0 – 100% CSF
0 – 100% CSF
See Note CSF
See Note CSF
See Note CSF
See Note CSF