Disable the SIMULATE parameter.
(Set Remote Indicator for normal
operation.)
Enable the SIMULATE parameter.
(For testing or debugging purposes.)
Enabling simulation mode
The SIMULATE parameter is enabled by setting the hardware simulation jumper to the "ON"
position.
Simulation mode truth table
Table 37 shows the states of the simulation jumper and SIMULATE parameter shows how to
activate the simulation mode.
When the Simulation
Jumper
(HW_SIMULATE_JUMPE
R_STATE) on Transducer
board is set to:
"OFF" Position
"ON" Position
Revision 4
Foundation Fieldbus RMA803 Remote Indicator User's Guide
Table 36: Setting the Simulation Jumper
To
"OFF" position on the Transducer board.
"ON" position on the Transducer board.
Table 37: Simulation Mode Truth Table
and the SIMULATE Enable_Disable is set to:
(Disabled)
Simulation Disabled
Simulation Disabled
Set the Jumper to:
(Active)
Simulation Disabled
Simulation Active
Page 113