Attributes - Honeywell SmartLine RMA800 User Manual

Parameter
BIAS_IN_1
GAIN_IN_1
BIAS_IN_2
GAIN_IN_2
BIAS_IN_3
GAIN_IN_3
COMP_HI_LIM
COMP_LO_LIM
ARITH_TYPE
BAL_TIME
BIAS
GAIN
OUT_HI_LIM
OUT_LO_LIM
UPDATE_EVT
BLOCK_ALM
LICENSE_STATU
S_AR

Attributes

Supported
Modes
Alarm Types
Status
Handling
Page 82 Foundation Fieldbus RMA803 Remote Indicator User's Guide
The bias value for IN_1.
The proportional gain (multiplier) value for IN_1.
The bias value for IN_2.
The proportional gain (multiplier) value for IN_2.
The bias value for IN_3.
The proportional gain (multiplier) value for IN_3.
Determines the high limit of the compensation input.
Determines the low limit of the compensation input.
The set of 9 arithmetic functions applied as compensation to or
augmentation of the range extended input.
Specifies the time for a block value to match an input, output, or
calculated value or the time for dissipation of the internal balancing bias.
The bias value is used to calculate the output.
The gain value is used to calculate the output.
The maximum output value allowed.
The minimum output value allowed.
This alert is generated by any changes to the static data.
Used for all configuration, hardware, connection failure, or system
problem in the block. The cause of the alert is entered in the subcode
field. The first active alarm sets the active status in the status parameter.
When the Unreported status is cleared by the alert reporting test, other
block alert may be reported without clearing the Active status, if the
subcode has changed.
License status of the function block.
The block supports the following modes:
•
AUTO (Automatic)
•
MAN (Manual)
•
OOS (Out of Service).
The block supports standard block alarms, (see section 5.2).
The INPUT_OPTS bit string controls the use of auxiliary inputs with
less than Good status. The status of unused inputs is ignored.
The status of the output is the worst of the inputs used in the
calculation after applying INPUT_OPTS.
Description
Revision 4