The Advanced Display Menus
The Advanced Display menus are organized into three levels, as shown by Table 7. There is a
<Return> menu item at each level that allows the user to return to the previous level.
Level 1
<Exit>
Diagnostics
Display Setup
Information
All Diagnostics menu items are Read Only.
<Return> Return to the Level 1 menu
<Return>
Active Diags
Critical
Elec. Module
<Return>
Active Diags
Non-
Critical
Supply Voltage
Elec Module Temp
Page 18
Foundation Fieldbus RMA803 Remote Indicator User's Guide
Table 7: Advanced Display Main Menu Structure
Level 2
n/a
n/a
Critical
For details go to the Diagnostics Menu table.
Non-Critical
For details go to the Display Setup Menu table.
LCD Contrast
Common Setup
Note that the Advanced Display supports the
Screen 1
configuration of up to 8 different screens.
Screen 2
Note that only LCD Contrast, Rotation time, and
...
Rotation Enable are editable parameters. Rest all are
Screen 8
read only.
Display
Elec Module
For details go to the Information Menu table.
Model
Options
Table 8: Diagnostics Menu
# #
OK
FAULT
# #
OK
LOW
HIGH
OK
OVER TEMP
Level 3
Shows the number of Critical Diagnostics that
are currently active.
FAULT: There is a problem with the
Electronics Fieldbus Communication Module.
Shows the number of Non-Critical Diagnostics
that are currently active.
OK: Supply voltage is within the specification
limit
LOW: Supply voltage is below the low
specification limit
HIGH: Supply voltage is above the high
specification limit.
OVERTEMP: Electronics temperature is
greater than 85 Deg C
Revision 4