Annex 2: Installation And System Turn On Progress List - Pylontech PowerCube-X1 Operation Manual

Annex 2: Installation and System Turn ON Progress List

Tick after
No.
completion
☐
1
☐
2
☐
3
☐
4
☐
5
☐
6
☐
7
☐
8
☐
9
☐
10
☐
11
☐
12
☐
13
☐
14
The environment is meeting all technical requirements.
3.3.1 Cleaning
3.3.2 Temperature
3.3.3 Radiating System
3.3.4 Heating System
3.3.5 Fire-extinguisher System
3.3.6 Grounding System
Battery rack is installed
requirements.
Control Module (BMS) and Battery Module are installed
well.
The MBMS are installed well. (If configured.)
Connect External Power Cable +/- between each BMS
to the PCS or confluence cabinet.
Connect power cables of each battery string.
Connect communication cables of each battery string.
Set up ADD switch of every BMS and the MBMS (Address
Assignment).
Connect external communication cables from BMS to
BMS, MBMS, inverter, PCS or another.
Connect the communication cable from MBMS to the
PCS.
Double check every power cables, communication
cables installed well. And ADD Switches are setting right.
Check the UPS is turned on. And the UPS is power
supplying. (If configured)
Switch the external power or PCS on, to sure all the
power equipments can work normally.
Turn the BMS (Battery Control Modules) of each battery
string on (from 1 BMS to the last, one by one)
st
Turn on the "Power Switch":

 Turn on the "Start Button":
The battery string's system will check itself, if

work normal the battery string system will goes
into
self-check
If has failure during the self-check, must debug
the failure then can start next step.
Item
follow the
mode.
41
Remark
Refer to chapter
3.3
technical Refer to chapter
3.5.3.
Refer to chapter
3.5.4.
Refer to chapter
3.5.5.
Refer to chapter
3.6.2.
Refer to chapter
3.6.2.
Refer to chapter
3.6.2.
Refer to chapter
3.6.3.
Refer to chapter
3.6.2.
Refer to chapter
3.6.2.
Refer to chapter
3.6.2 and 3.6.3.
Refer to chapter
3.6.4.
Refer to chapter
3.6.4.
Refer to chapter
3.6.4.