Setup And Programming; Overview; Front Panel Buttons And Status Led Indicators - Ametek DDMC Instruction Manual

DDMC Analog Input Process Meter / Controller

Setup and Programming

There is no need to recalibrate the meter
when first received from the factory.
The meter is factory calibrated prior to
shipment for milliamps and volts with
calibration equipment that is certified to NIST
standards.

Overview

There are no jumpers to set for the meter input
selection.
Setup and programming is done using DDMC Meter
View or through the front panel buttons.
After power and input signal connections have been
completed and verified, apply power to the meter.
Front Panel Buttons and Status
LED Indicators
Button Description
Symbol
Menu
Right
arrow/F1
Up arrow/F2
Enter/F3
Note:
F4 is a digital input. Alarms
5-8 are enabled when relay
expansion module is
installed.
Press the Menu button to enter or exit the
•
Programming Mode at any time.
Press the Right arrow button to move to the next
•
digit during digit or decimal point programming.
• Press or hold the Up arrow button to scroll
through the menus, decimal point, or to
increment the value of a digit.
• Press the Enter button to access a menu or to
accept a setting.
Press and hold the Menu button for three
•
seconds to access the advanced features of the
meter.
19
Instruction Manual
LED Status
Alarm 1-8
1-8
indicator
Flashing:
1-8
Relay in
manual
M
control mode
Flashing:
T
Tare
Flashing:
Relay
1-8
interlock
switch open
Note:
LEDs for relays in
manual mode flash
with the "M" LED every
10 seconds. "M"
flashing by itself
indicates Aout –
manual control is used.