Communication Success Rate - Mitsubishi Electric ER-1V680D1 User Manual

Communication success rate

This function is used to communicate 100 times and calculates the success rate.
Use this function to adjust the installation location.
Measuring using programs
This section describes the method to calculate the communication success rate.
1.
Check of parameters
Check that "Enable" is set to "Enable channel 1 TEST mode", "Enable channel 2 TEST mode (ER-1V680D2 use)" and
"Enable Y contact test request".
2.
Operation setting of TEST mode
Set "00C1H" to Test operation mode specification area (Un\G8000).
3.
Setting of antenna
Set the antenna to be tested to Test operation antenna specification area (Un\G8001).
4.
Setting of the number of processing points during testing
Set the number of test operation bytes to No. of processing points during testing specification area (Un\G8002).
5.
Starting to communicate with RF tag
When TEST mode execution request (Y15) is turned on, the module communicates with the RF tag.
6.
Check of test results
The test results are stored in Processing result monitor storage area (Un\G42, Un\G4042). ( Page 82 Test results)
Ex.
Program that starts a test under the following conditions when M2 turns on
• Operation mode: TEST mode (Communication success rate)
• Test operation antenna specification: Antenna 1
• No. of processing points during testing specification: 1 byte
6
6 FUNCTIONS
81
6.4 Test Function