Table of Contents
Advertisement
2
SPECIFICATIONS
This chapter describes the general specifications and performance specifications of RFID interface module.
2.1
General Specifications
Item
Operating ambient temperature
Storage ambient temperature
Operating ambient humidity
Storage ambient humidity
Vibration resistance
Shock resistance
Operating atmosphere
*1
Operating altitude
Installation location
*2
Overvoltage category
*3
Pollution degree
Equipment class
*1 Do not use or keep this product in the environment pressurized over the atmospheric pressure at an altitude of 0m. Doing so can cause
malfunction.
*2 This indicates which distribution part is assumed to be connected to the product in the public electrical power distribution network or in
the on-site machinery. The category applies to the devices powered by the fixed equipment. The surge voltage withstand of the
product whose rated voltage is up to 300V is 2500V.
*3 This degree is the index value to indicate the occurrence rate of conductive materials in the operating environment. The pollution degree
2 means the situation where the non-conductivity materials occur. However, temporary condensation can occur due to accidental
condensation.
*4 Using the product at the high altitude over 2000m lowers the upper limit of withstand voltage and operating ambient temperature. In this
case, the product can malfunction.
*5 Install the RFID interface module in the control panel that satisfies IP20 protection classification and Type 1 or higher level specified in
UL50. Design the control panel suitable for the environment if necessary.
2 SPECIFICATIONS
20
2.1 General Specifications
Specifications
0 to 55
-25 to 75
5 to 95%RH, no condensation
5 to 95%RH, no condensation
Compliant with
JIS B 3502, IEC
61131-2
Place with
intermittent
vibration
Place with
continuous
vibration
Compliant with JIS B 3502, IEC 61131-2 (147m/, three times in each direction of X, Y, and Z)
No corrosive gas, no flammable gas, and little conducting dust
*4
0 to 2000m
*5
In a control panel
or lower
2 or lower
Class
Frequency
Acceleration
5 to 8.4Hz
8.4 to 150Hz
9.8m/
5 to 8.4Hz
8.4 to 150Hz
4.9m/
Amplitude
Number of
sweeps
3.5mm
10 times in each
direction of X, Y,
and Z
1.75mm
Advertisement
Table of Contents
Troubleshooting
