Repeat Auto - Mitsubishi Electric ER-1V680D1 User Manual

Repeat auto

This command is used to automatically detect an RF tag coming into the antenna communication area and communicate with
the tag. Communicates with RF tags coming into the communication area one after another until ID command execution
request (Y14, Y1C) is turned off.
When using this command, set 0002H to Communication specification area (Un\G1, Un\G4001).
RF tag C
• When ID command execution request (Y14, Y1C) is turned on, ID-BUSY (X3, XB) turns on. The module starts to
communicate with an RF tag coming into the antenna communication area.
• After communication with the RF tag, ID command complete (X4, XC) turns on. When result reception (Y16, Y1E) is turned
on, ID command complete (X4, XC) turns off and the module starts to detect the next RF tag entering the antenna
communication area.
• When ID command execution request (Y14, Y1C) is turned off, ID-BUSY (X3, XB) turns off and the module ends to detect
an RF tag.
• Set only one RF tag in the antenna communication area.
• When the time specified in Auto command wait time setting area (Un\G10, Un\G4010) elapses before a communicable tag
enters the communication area, the status flag (bit 10) of Error details storage area (Un\G41, Un\G4041) and Error
detection (X5, XD) turn on.
• The module does not re-communicate with the RF tag remaining in the communication area.
RF tag B
Communication area
RF tag A
6.3 Communication Specification
6
6 FUNCTIONS
69