Mitsubishi Electric ER-1V680D1 User Manual page 133

■Processing result monitor storage area (Un\G42, Un\G4042)
Depending on the setting of Processing result monitor switch setting area (Un\G11, Un\G4011), the noise level and
communication time are stored in the storage area. (Page 129 Processing result monitor switch setting area (Un\G11,
Un\G4011))
This area is used to store the results of tests during the TEST mode.
Test description
Communication test
Communication success rate
Speed level (read)
Speed level (write)
Noise level
■RF tag UID storage area (Un\G90 to Un\G93, Un\G4090 to Un\G4093)
This area is used to store the UID (unit identification number) of communicated RF tag.
Read/Write data
■Data storage area (Un\G100 to Un\G1123, Un\G4100 to Un\G5123)
For the Read command, data to be read is stored. For the Write command, data to write is stored
Processing result
■When completed successfully (processing time)
0000 to 9999 [BCD] (in units of 10ms)
■When completed with an error (E0 + error code)
E070H: Tag communication error
E072H: Tag not present error
E079H: ID system error 1
E07AH: Address error
E07CH: Antenna error
■When completed successfully (C1 + measurement result)
C101 to C199 [BCD] (Unit: %)
C1EE: 0%
C1FF: 100%
■When completed with an error (E0 + error code)
E07CH: Antenna error
■When completed successfully (B0 + measurement result)
B001 to B099 [BCD] (Unit: Number of times)
B0EE: 0 times
■When completed with an error (E0 + error code)
E07CH: Antenna error
■When completed successfully (B1 + measurement result)
B101 to B199 [BCD] (Unit: Number of times)
B1EE: 0 times
■When completed with an error (E0 + error code)
E07CH: Antenna error
■When completed successfully (C0 + measurement result)
C000 to C099 [BCD] (maximum value)
■When completed with an error (E0 + error code)
E07CH: Antenna error
APPX
Appendix 3 Buffer Memory
A
131