5
PARAMETER SETTING
This chapter describes the parameter setting of RFID interface module.
5.1
Setting Procedure
1.
Install the profile, module label, and module FB to the engineering tool. ( Page 32 Profile installation)
2.
Add the RFID interface module to the engineering tool.
[Navigation Window] [Parameter] [Module Information] Right-click [New Module Addition]
In the engineering tool, "Partner Products" represents "Module Type", and "007ER-1V680D1" or "007ER-1V680D2" represent
"Module Model Name".
3.
Select the parameter from the tree of the following window to set.
[Navigation Window] [Parameter] [Module Information] Module model name [Module Parameter]
4.
Write the settings to the CPU module using the engineering tool.
[Online] [Write to PLC]
5.
Reset or power off and on the CPU module to reflect the settings.
5 PARAMETER SETTING
5.1 Setting Procedure
5
31