Requirements For Low Voltage Directive Compliance - Mitsubishi Electric ER-1V680D1 User Manual

■Ferrite core
A ferrite core is effective for reducing interference caused by high-frequency noise (0.5MHz to 80MHz frequency band).
For an antenna cable that extends from the control panel, install a ferrite core with the damping characteristics equivalent to
that of the ZCAT3035-1330 (manufactured by TDK Corporation), 15cm or less away from the module. Wrap the cable around
the ferrite core by one as shown below.
(Ferrite core used for the tests conducted by Mitsubishi Electric Engineering Co., Ltd.: ZCAT3035-1330 (manufactured by
TDK Corporation)
Manufacturer
TDK Corporation

Requirements for Low Voltage Directive compliance

The RFID interface module uses the inner circuit with a 24VDC rating or lower, so the module is outside the scope of the Low
Voltage Directive.
APPX
142
Appendix 5 EMC and Low Voltage Directives
Contact
www.global.tdk.com